Video Tips: Parallel Part by Part Meshing in ANSYS v15.0

This video shows you a new capability in ANSYS v15.0 that allows multiple parts to be simultaneously meshed on multiple CPU cores…with no additional licenses required!

Exercising Parallel Meshing in ANSYS Mechanical R15

[The following is an email that Manoj sent the tech support staff at PADT. I thought is was perfect for a The Focus posting, so here it is – Eric]

First of all I found out a way to get Mesh Generation time (if no one knew about this).  In ANSYS Mechanical go to Tools->Options->Miscellaneous and turn “Report Performance Diagnostics in Messages” to Yes.  It will give you “Elapsed Time for Last Mesh Generation” in the Messages window.



Next I did a benchmark on the Parallel Part by Part meshing of a Helicopter Rotor Hub with 502 bodies.  The mesh settings were getting a mesh of about 560,026 elements and 1.23 million nodes.


I did Parallel Part by Part Meshing on this model with 1,2,4,6 and 8 cores and here are the results.

Can I say “I LIKE IT!”

1 core: 172 seconds (1.0)
2 core:  89 seconds (1.9)
4 core:  52 seconds (3.3)
6 core:  38 seconds (4.5)
8 core:  33 seconds (5.2)


Of course this is a small mesh so as the number of cores goes up, the benefits go down.   I will be doing some testing on some models that take a lot longer to mesh but wanted to start simple. I’ll make a video summarizing that study showing how to set up the whole process and the results.

If you are curious, Manoj is running on a PADT CUBE server. As configured it would cost around $19k. You could drop a few thousand of the price if you changed up cards or went with CPU’s that were not so leading edge.

Here are the SPECs:

CUBE Mid-Tower Chassis – 26db quiet edition
Two XEON e5-2637 v2 (4 cores per, 3.5GHz each)
128 GB of DDR3-1600 ECC Reg RAM
7.1 HD Audio (to really rock your webinars…)
SMC LSI 2208 RAID Card – 6Gbps
OS Drive: 2 x 256GB SSD 6gbps
Solver Array: 3 x 600GB SAS2 15k RPM 6Gbps